PALECEK ANGELO 793600 Assembly Instructions

These instructions are provided for your convenience. It is very important that they are read carefully and completely before
beginning assembly of this item.(Applies to item 793600)

TOOLS NEEDED:

1. Allen Wrench (Provided).

TO ASSEMBLE:

1. Unpack contents and place on a non scratching surface like a blanket or carpeting.
2. Place Table Top (A) upside down on a non scratching surface.
3. Place Table Base (B) upside down onto Table Top (A), ensuring that the bolt holes align.
4. Insert Hex Bolt (C) through Lock Washer (F), and Flat Washer (E), then insert into perimeter Table Base (B) holes. Tighten
loosely.
5. Repeat with remainder of Hex Bolts and Washer sets (10 total). Once all bolts are inserted, tighten firmly without over tighten-
ing.
6. Turn assembled table right-side-up and place in desired location.
7. If floor is uneven, use the adjustable levelers under each leg to make contact with floor.
8. Assembly complete.

CARE:

Dust with a soft dry cloth. Wipe up spills immediately. Do not use cleaning solutions or abrasives. Clean with mild soap
on damp cloth. Rinse with clean damp cloth.
6 0 1 P A R R B O U L E V A R D , R I C H M O N D , C A 9 4 8 0 1
ROUND DINING TABLE ASSEMBLY INSTRUCTIONS
T . 8 0 0 . 2 7 4 . 7 7 3 0 | F . 5 1 0 . 2 3 4 . 7 2 3 4
C
D
E
F
P A L E C E K . C O M
Page 1