EMS EC-63-0001 Installation Manual

Conventional Interface Card (CIC)
Installation Guide
SOUNDERS
EOL L1 L2
(+) (-)
1 Pre installation
When fitted to the zone interface module (ZIM), the conventional interface
card (CIC) enables 30 FireCell wireless devices to be added to an existing
conventional fire panel, via a wireless zone monitor (WZM).
ZIM with
CIC fitted WZM
FC-ZIM-001 POWER
FAULT
WIRELESS ZONE MONITOR
*
Conventional
fire panel
3 Connect CIC to the ZIM
Ensure the pins line up with the ZIM's terminal connections as shown.
SOUNDERS
EOL
5 Fasten the ZIM's terminals
©2022 EMS Ltd. All rights reserved.
FAULT ZONE/RESET
EOL
EOL L1 L2 ALARM L1 L2
RES
(+) (-) (+) (-) (+) (-) (+) (-) (+) (-) (+) (-)
FireCell wireless devices
*
Designated zone
and sounder circuits.
FAULT ZONE/RESET
L1 L2 EOL L1 L2 EOL L1 L2
ALARM
RES
Part no Product description
EC-63-0001 EMS Conventional Interface Card
2 Pre installation
Installation must conform to applicable local installation codes
!
and should only be installed by a fully trained competent person.
Only fit the CIC to the zone interface module (ZIM), when connecting to
•
a conventional fire panel.
• The CIC should only be connected to designated zone and sounder
circuits.
• Refer to the EMS wireless zone monitor engineers guide (TSD143) for full
programming information.
• Refer to the conventional control panel compatibility document (MK58)
for details of compatible conventional fire alarm panels.
• This device contains electronics that may be susceptible to damage
from Electrostatic Discharge (ESD). Take appropriate precautions when
handling electronic boards.
4 Fasten the CIC PCB into the ZIM
6 Connection wiring
• The CIC can be wired in two different ways.
• Fault notification can either be monitored via the conventional fire panel's
sounder or zone circuit.
• See overleaf for the alternative wiring methods.
Page 1 of 2
SOUNDERS FAULTZ ONE/RESET
EOL L1 L2 EOL L1 L2 ALARM EOL L1 L2
RES
TSD147-99 Issue 7 21/06/2022 AJM