EMS EC-63-0001 Installation Manual

Conventional Interface Card (CIC)
Installation Guide
SOUNDERS
EOL L1 L2
(+) (-)
1 Introduction
The conventional interface card (CIC) when fitted to the zone
interface module (ZIM), enables 30 FireCell wireless devices to be
added to an existing conventional fire panel, via a wireless zone
monitor (WZM).
ZIM with
CIC fitted
WZM
FC-ZIM-001 POWER
FAULT
WIRELESS ZONE MONITOR
*
Conventional
fire panel
3 Connect CIC to the ZIM
Ensure the pins line up with the ZIM's terminal connections as
shown.
SOUNDERS
EOL L1 L2
5 Fasten the ZIM's terminals
©2021 EMS Ltd. All rights reserved
FAULT
ZONE/RESET
EOL
EOL L1 L2 ALARM L1 L2
RES
(+) (-) (+) (-) (+) (-) (+) (-) (+) (-) (+) (-)
FireCell wireless devices
*
Designated zone
and sounder circuits.
FAULT ZONE/RESET
EOL L1 L2 ALARM EOL L1 L2
RES
Part no Product description
EC-63-0001 EMS Conventional Interface Card
2 Pre installation
Installation must conform to applicable local installation
!
codes and should only be installed by a fully trained
competent person.
Only fit the CIC to the zone interface module (ZIM), when
connecting to a conventional fire panel.
The CIC should only be connected to designated zone and
sounder circuits.
Refer to the EMS wireless zone monitor engineers guide
(TSD143) for full programming information.
Refer to the conventional control panel compatibility document
(MK58) for details of compatible conventional fire alarm panels.
This device contains electronics that may be susceptible to
damage from electrostatic discharge (ESD). Take appropriate
precautions when handling electronic boards.
4 Fasten the CIC PCB into the ZIM
6 Connection wiring
The CIC can be wired in two different ways.
Fault notification can either be monitored via the conventional
fire panel's sounder or zone circuit.
See overleaf for the alternative wiring methods.
Page 1 of 2
SOUNDERS FAULT ZONE/RESET
EOL L1 L2 EOL L1 L2 ALARM EOL L1 L2
RES
TSD147-99 Iss 6 15/12/2021 AJM