VALBERG CYCLONIC-S12 AUTO Instructions For Use Manual page 29

C
Cleaning and maintenance
Hold the main unit vertically over a bin. Press the dust cup lid release lever.
The lid on the bottom of the dust cup will flip open. Close the lid after emptying the
contents.
Detaching the dust cup and filters
Hold the bottom of the dust cup with one hand. Press the dust cup release button
with the other hand and pull the dust cup away from the main unit.
Lift the foam filter and then the permanent filter out of the dust cup.
Tap the filters over a bin to dislodge the dust. Make sure the foam filter is tapped
from above. Do not turn the filter upside down or tap the underside.
Rinse the dust cup, the permanent filter and foam filter under a tap.
Shake off any excess water and dry all parts completely.
• To re-assemble the filters and dust cup, carry out the steps in reverse order.
• Make sure you align the two nodules on the rim of the permanent filter with the grooves
on the dust cup when you slot them together.
• Place the foam filter on top, white side up.
• Insert the assembled dust cup onto the main unit, making sure to align the two parts
correctly and then push the dust cup until it clicks into place.
WARNING! To prevent damage to the unit, only use dry,
intact filters!
Cleaning the bristles/roller brush and wheels
If the bristles/roller brush or wheels of the motorised brush become blocked or jammed,
turn off the unit.
Cleaning the bristles/roller brush
Press the motorised floor brush release button and separate the motorised floor
brush from the extension tube.
28 EN