Table of Contents
Advertisement
TILLING WIDTH
There are three tilling widths available.
Remove the spark plug wire from spark plug and
ground before making any adjustments to tine width
1. Standard tilling width is 18 inches See figure 15
FIGURE 15.
2. A narrower width (14 inches) can be obtained by
removing Doth outer tines. Use a 3/8" wrench to
remove the two self-tapping screws on the outside
of the tines. See figure 16. Replace the first tine
removed as shown in figure *7.
FIGURE 17.
3. The minimum tiller width that can be obtained is
10 inches. Remove the outer tines by removing the
two self-tapping screws on the outside of the tines,
See figure 18.
FIGURE 18.
CLUTCH ADJUSTMENT
Refer to step numbers 8 and 9 of Assembly Instructions
for clutch adjustment information.
CARBURETOR ADJUSTMENT
AC
WARNING
\
If any adjustments are made to the
engine while the engine is
running
(eg.
carburetor),
disengage
all
clutches and tines.
Keep dear of
all
moving
parts.
Be
careful
of
heated surfaces and muffler.
9
Advertisement
Table of Contents
