Table of Contents
Advertisement
OPERATION
Clutch
Grip
BEFORE STARTING ENGINE
1
Check clutch adjustment before starting tiller.
Refer to step number 9 of Assembly Instructions.
2. Fill crankcase with 1
Va
pints of oil or to top of filler
neck. Be sure that the engine is level See figure
10
.
Use SAE No. 30 MS. SC. SD or SE oil. If not
available, use SAE 10W-30.
FIGURE 11.
3. Pull choke knob out to choke engine. See figure
12
.
4. Move the throttle control lever forward to FAST
POSITION. See figure 11.
5. Standing at side of the tiller, grasp the starter han¬
dle and pull out rapidly. Return it slowly to the
engine. Repeat if necessary.
6. After engine starts, push choke knoD gradually in
to "OFF" position.
NOTE
Warm engine should not need chok¬
ing.
FIGURE 10.
3. Fill fuel tank using a good grade of fresh, clean,
regular gasoline. Do not use gasoline that has
been sitting for a long period of time
TO START ENGINE
A
J WARNING
\
BE SURE NO ONE IS STANDING IN
FRONT OF THE TILLER WHILE THE
ENGINE
IS
RUNNING
OR
BEING
STARTED
1
Attach spark plug wire to spark slug
2
Be certain the clutch grip is m the r eutral ueleased)
position. See figure 11
TO STOP ENGINE
1, Move throttle contrcl lever to ' STOP" position.
2
Disconnect spark piug wire from spark plug to pre¬
vent accidental starting while equipment is unat¬
tended
7
Advertisement
Table of Contents
