White Outdoor Products ROTO BOSS 310 Instruction Manual page 6

8
. Hook the "Z" end of clutch cable wire into bottom
— hole of clutch grip. See figure 7.
9. Hold the clutch grip so that the grip is down against
the handle. Adjust the clutch control cable so that
the slack is taken out of the control wire. Tighten
the two hex nuts at the cable support bracket. Con¬
trol wire should now be straight.
NOTE
Do not overtighten control wire. Too
much tension may cause it to break.
FIGURE 7.
10
. To check the adjustment, disconnect the spark
plug wire from spark plug to prevent accidental
starting. Secure end of spark plug wire in the "V"
— Slot on the engine. See figure 8. With the clutch
grip released (neutral position), pull starter cord
several times.
The tines should not turn.
If they
do, adjust the hex nuts at the clutch cable bracket.
Check again for correct adjustment.
FIGURE 8.
11
.-Secure the clutch cable and throttle cable to the
upper handles with cable ties
(D)
provided in hard-
-ware pack. See figure 9. Cut off excess end.
FIGURE 9.
6