White Outdoor Products ROTO BOSS 310 Instruction Manual page 4

NOTE
Reference to left or right side of the
tiller is determined from behind the
unit in the operating position.
ASSEMBLY
This unit is shipped WITHOUT GAS¬
OLINE or OIL. After assembly, see
separate engine manual for proper
fuel and engine oil recommenda¬
tions.
Contents of Hardware Pack (See Figure 1):
-A (4) Carriage Bolts 5/16-18 x IV
2
" Long
B (4) Lock Washers 5/16" l.D.
C (4) Hex Nuts 5/16-18 Thread
D (2) Cable Ties
E (2) Curved Head Bolts
F (2) Belleville Washers 5/16" l.D.
G (2) Hand Knobs
FIGURE 1.
Loose Parts in Carton:
-(1) Upper Handle—R.H.
(1) Upper Handle—L.H.
(1) Handle Panel
Tools Required
(2) V
2
" open end or box wrenches
1
. Remove the tiller from the carton. Make certain all
parts and literature have been removed before the
carton is discarded.
2
. Extend the control cables and place on the floor.
Be careful not to bend or kink the cables.
3. There are two height positions for the upper
handles. Place left hand upper handle (with clutch
grip and cable support bracket already assembled)
in position on lower handle, selecting hole for either
high or low position. Secure with curved head bolt
(E), belleville washer (F) (cupped side against the
—handle) and hand knob (G). See figure 3. Do not
tighten at this time. Assemble right hand upper
handle in the same manner.
FIGURE 3.
4