Simplicity 6100 Series Operator's Manual page 14

CHECK FUEL FILTER
3. Install new filter in proper flow direc¬
tion in hoses. Secure by reclamping
with hose clamps. See warning above.
CHECK/ADD GASOLINE
WARNING
Do not remove fuel filter when engine
is hot, as spilled gasoline may ignite.
Do not spread hose clamps further
than necessary. Insure clamps grip
hoses firmly over filter after installa¬
tion.
If the filter (see figure 6) is dirty or clogged,
service as follows.
1. Using a pliers, open and slide hose
clamps from fuel filter.
2. Remove hoses from filter.
Clean the area around the gas/gauge cap
then remove the cap. Fill the tank with clean,
fresh, leaded or lead-free regular grade gaso¬
line. Install and hand tighten the gas/gauge
cap.
WARNING
Never add gasoline when engine is hot
or running.
A. Pull out at this point on each side and lift
the hood.
Figure 6. Raising Hood & Seat Deck
B. Reach under the left seat deck and press
the latch up. The entire seat deck tilts back.