Entering A Password (Ratings); Led; Red Use A - Panasonic DMR-T3040 Operating Instructions Manual

| Changing the unit's settings
Advanced operation a
Numbered
buttons
CANCEL
Common procedures
See page 60 for menu and option details.
1 While stopped
Press [SET UP] to show the menus.
CATV .
d Auto Channel Setting | ^
'CERT -
" | . Preset Channet Caption | -<.<
fq Manual Channel Captio >
PE ca Lam > y
)
Fret Sort rte ree Di
i ACC
Tabs Menus Options
Press [A, V] to select the menu's tab
and press [P]. |
Press [A, V] to select the menu and
press [ENTER].
Press [A, V] to select the option and
press [ENTER].
The screen now shows the menu again.
e Some items require different operations. Read the following
explanations.
To return to the previous screen
Press [RETURN].
When you are finished
` Press [SET UP}.
62
ROT6637
Entering a password (Ratings)
Ca
The password screen is shown when you select levels O to 7.
1. Input a 4-digit password with the numbered buttons.
eif you enter a wrong number, press [CANCEL] to erase it.
2. Press [ENTER].
eThe lock symbol appears closed to show the rating is locked.
eDo not forget your password.
3. Press [ENTER] to confirm the 4 digits.
If you insert a DVD-Video that exceeds the ratings limit you set, a
message appears on the television.
Follow the on-screen instructions.
Digital Audio 'Output
Change the settings when you have connected equipment through
this units DIGITAL AUDIO OUT terminal ("page 57, Ey.
Select the "Audio" tab and then "Digital Audio Output" by
following "Common procedures" {+ left) to set up "PCM Down
Conversion", "Dolby Digital" and "DTS",
PCM Down Conversion
Select how to output audio with a sampling frequency of 96 kHz.
Select "On" if the equipment you connect cannot process signals
with a sampling frequency of 96 kHz.
e Select "Off" if you use analog connect irrespective of the type of
equipment.
Off (Factory preset):
Output as 96 kHz. There is no output if the disc has copy protection.
Select "On" in this case.
On:
Converted to 48 kHz for output.
Dolby Digital and DTS
|
Bitstream (Factory preset for Dolby Digital):
Select if the equipment you connected can decode the signal.
PCM:
Select if the equipment you connected cannot decode Dolby Digital
signal.
Off (Factory preset for DTS):
Select if the equipment you connected cannot decode DTS signal.
. IMPORTANT
If the equipment you connected cannot decode the signal, the
setting must be changed to PCM or Off. If not, signals the
equipment cannot process will be output by this unit, causing
high levels of noise which can damage your hearing and the
speakers.