Table of Contents
Advertisement
Troubleshooting Guide
If there is a problem, try to resolve it by referring to this Troubleshooting
Guide. If the problem still persists, take the camera to your nearest Canon
Service Center.
Nothing is
displayed on the
LCD panel.
The batteries are exhausted.
► Replace the batteries with new ones. (->page 16)
The batteries have been installed incorrectly.
► Install the batteries correctly. (->page 16)
The picture looks
blurred.
The lens focus mode is set to <MF> (or <M>).
*• Set the lens focus mode to <AF>. (^page 18)
There was camera shake when the picture was taken.
► Hold the camera steady or use a faster shutter speed.
(-^page 19)
The shutter does
not work.
The frame count is not displayed on the LCD panel.
»• Take out the film and load it correctly. (->page 20)
The
<fZ3>
icon blinks on the LCD panel.
► Replace the batteries with new ones. (->page 16)
The
<@i>
icon blinks while the rewound film is still in the
camera.
► Replace with a new roll of film. (->page 20)
The in-focus indicator < • > in the viewfinder blinks and focus
cannot be achieved.
► Select another AF frame. (->page 38)
If focus still cannot be achiev^, focus manually, {-^page 40)
The < dJ > icon
blinks on the LCD
panel.
The battery level is very low.
► Replace the batteries with new ones. (->page 16)
A misoperation has occurred.
► Press the shutter button halfway. (->page 19)
»• Remove and reload the batteries. (->page 16)
If the <C1I]> icon stops blinking, picture-taking is possible.
If it is still blinking, consult your nearest Canon Service
Center.
72
Advertisement
Table of Contents
