Installation Of Battery Pack In Handset - VTech vz2652 User Manual

Installation of Battery Pack in Handset

The original Handset that is shipped with your 2652 system will be
automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned
extension numbers in the following order: HANDSET 2, HANDSET 3 and
HANDSET 4.
Whenever a Handset battery pack is installed, the Handset will automatically
begin SEARCHING FOR BASE (if previously registered), or it will prompt you
to ENTER BASE ID to register the new Handset.
Follow the steps below:
1. Remove battery compartment
cover by pressing on the indent
and sliding downward.
2. Place the new battery pack in
the Handset with the metal
contacts aligned with the charge
contacts
compartment.
3. Replace
compartment cover by sliding it
upwards.
4. If the new battery pack is not
already charged, place the
Handset in the Base Unit, or a
charging stand, and allow it to
charge for 10-12 hours. After
initial charge, a maintenance
charge of 8 hours should be
sufficient.
8
in the battery
the battery