To Store A Number Into Memory; To Speed Dial A Stored Number; To Change Or Replace Astored Number; Storing A Pause In A Speed Dial Number - VTech vt9241 User Manual

OPERATING INSTRUCTIONS
TO STORE A NUMBER INTO
MEMORY
The Handset must be OFF.
0
TONE
OPER
HOLD CHAN
PGM CONF
MEM
1. Press PGM/MEM on Handset
2. Press the number of the memory
location you wish to store the phone
number in (0-9). The Handset will
beep once.
3. Using the dialpad, dial the number
you want to store. The number can
be up to 20 digits long.
4. Press PGM/MEM to store the num-
ber into its assigned memory loca-
tion.
• If programming has been success-
ful, a happy tone will be generated.
• If programming was unsuccessful,
a sad tone is generated.
• If more than 20 digits are keyed in
or the phone is left unattended in
program mode for more than 30
seconds, it will generate a sad tone
and automatically exit program
mode.
• Follow the steps above for each
number you want to store, assign-
ing each phone number to a differ-

TO SPEED DIAL A STORED NUMBER

You can speed dial from the Handset
or Base Unit.
1. Press LINE1 or LINE2 to get a dial
INT.COM
REDIAL
PAUSE
2. Press PGM/MEM on the Handset
3. Press the number key (0-9) to en-
For example, to dial the number you
assigned to key '8', you would press
LINE (1 or 2), MEMORY, 8 on the Base;
or LINE (1 or 2), PGM/MEM, 8 on the
Handset.
TO CHANGE OR REPLACE A
STORED NUMBER
You can change or replace a stored
number just by storing a new number
in its place.
STORING A PAUSE IN A SPEED DIAL
NUMBER
To insert a pause in a phone number,
press REDIAL/PAUSE at the appropri-
ate point when storing the number. This
inserts a 2 second pause. For longer
20
ent memory key.
tone.
900
INT.COM/PAGE
CORDLESS
LINE 1
OFF
FLASH
1 2
ABC
4 5
GHI JKL
or MEMORY on the Base.
ter the memory location.
MHz
LINE 2
FLASH
3
DEF
6
MNO