Table of Contents
Advertisement
Getting Started
Wall mounting
The telephone base can be installed on any standard wall-phone outlet as shown
below. Choose a location away from electronic equipment, such as television sets
or microwave ovens. Avoid excessive heat, cold, dust or moisture.
Connect cords as shown on page 5, then press and slide
down firmly so base is held securely on outlet mounting pegs
Connect AC adapter and USB
cable as shown on page 5
Plug line cord into
telephone jack
6
Getting Started
Telephone base installation
Install the base as shown below. Choose a location away from electronic
equipment, such as television sets or microwave ovens. Avoid excessive heat,
cold, dust or moisture.
NOTE: It is recommended that you keep the base connected to a single computer. Moving the base from one
computer to another could corrupt the Caller ID List and Redial functionality of your handsets.
Plug base power cord
transformer into
electrical outlet not
controlled by a wall
switch
Underside of telephone base
NOTE: Use only the power cord supplied with this product. If you need a replacement, call 1-888-347-2005.
After charging the handset batteries
for at least 15 hours, plug line cord
into telephone jack.
Computer
Plug USB cable into a
USB port in your computer
Route wires under strain-
relief tabs as shown
7
Advertisement
Table of Contents
Need help?
Do you have a question about the USB 7200 and is the answer not in the manual?
Questions and answers