Getting Started; Installation Of Battery Pack In Handset - Sprint sp9127 User Manual

Vtech sp9127: user guide
Table of Contents

Advertisement

Installation of Battery Pack in Handset

The Handset of your 9127 is powered by a rechargeable battery pack. It charges
automatically whenever the Handset is in the Base Unit. The battery pack needs charging
when:
The low battery icon and message are displayed:
A double beep sounds.
To charge the battery pack, place the Handset in the Base Unit. The IN USE/CHARGING
indicator will light to show the Handset is seated properly and the battery pack is charging. It
is recommended that the battery pack should be charged for at least 16 hours initially.
Afterwards, 8 hours of maintenance charging should be sufficient.
To install (or replace) the battery pack:
1. Remove the battery case cover by pressing on the ridged lines and sliding downward.
2. Discard the old battery pack by pulling firmly on the battery cords. Don't put the old
battery pack in the trash or a fire - it could explode. Please recycle.
3. Snap in the new battery pack, with the wires in one of the lower corners. Insert the
battery plug into the socket, aligning the two holes in the plug with the socket pins.
4.
5.
IMPORTANT:
Do not dispose of this battery pack into household garbage. For
information on recycling or proper disposal, consult your local
solid waste collection or disposal organization.
1.
2.
3.
4.
To purchase replacement battery packs, call the Supplier at (800) 949-4357
Replace the battery case cover by sliding the cover
upwards.
Place the Handset in the cradle of the Base Unit to allow
it to charge for 16 hours.
CAUTION: To Reduce the Risk of Fire or Injury, Read and
Follow these Instructions:
Use only VTech rechargeable battery pack, or equivalent.
Do not dispose of the battery pack in a fire. The cell may
explode.
Do not open or mutilate the battery pack. Released electrolyte
is corrosive and may cause damage to the eyes or skin.
It may be toxic if swallowed.
Exercise care in handling batteries in order not to short the
battery with conducting materials such as rings, bracelets,
and keys. The battery pack or conductor may overheat and
cause burns.
6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the sp9127 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

9127

Table of Contents