Thermostat And Rain Sensor; Cleaning Instructions; Exhaust Vent; Operation - Airstream CLASSIC 2024 Owner's Manual

Interior

Thermostat and Rain Sensor

The fan is equipped with a built-in thermostat� Set
the fan to auto and select your comfort setting on the
Multiplex main touch control panel and the fan will
automatically turn on and off as your trailer heats up
and cools down� When the rain sensor becomes wet
the dome will close automatically and shut the fan off�
It will need to be manually restarted if the rain sensor
shuts off the fan� If you are using the Airstream Smart
RV Control app, you will get a notification if the rain
sensor is activated�

Cleaning Instructions

WARNING
Never operate the fan with the screen removed
and always disconnect power before cleaning or
servicing. Review the vent fan manufacturer's
cleaning instructions before cleaning or servicing
the fan.
To clean the screen, turn the fan motor and battery
disconnect switch OFF� The screen may be friction
held or have retainer clips that need turned halfway
to remove� Remove the screen and clean with a mild
soap and water solution� Carefully pat dry with a soft
cloth and reinstall�
NOTICE
The use of certain cleaners can cause cracking
and product failure. Review the vent fan
manufacturer's cleaning instructions before
cleaning or servicing the fan.
If your vent fails to operate properly under normal
conditions, please contact the manufacturer� Please
have the retail sales date and the vent Serial Number
readily available when you call� Refer to your operating
guide for contact information�
5-20

Exhaust Vent

Operation

The bath exhaust vent (shown above) removes
moisture from the air when using the shower� To
operate, you first need to open the vent.
To open the vent, push the button on the handle to
disengage the clip and slide the handle upward until
the clip engages�
Once open, turn the fan on by pressing the ON/
OFF button on the fan and/or by navigating to the
Fan Control page on the Multiplex control panel and
pressing ON�
Turn the fan off before closing the vent�
To close the vent, push the button on the handle to
disengage the clip and pull the handle down until the
clip engages in the lowered position�
NOTICE
Turn OFF the fan before closing the vent. Damage
to the motor can occur if the fan runs with the
vent closed.
Cleaning Instructions
WARNING
Never operate the fan with the screen removed
and always disconnect power before cleaning or
servicing. Review the vent fan manufacturer's
cleaning instructions before cleaning or servicing
the fan.
To clean the screen, turn the fan motor and battery
disconnect switch OFF� Remove the four retainer
screws� Clean the screen with a mild soap and water
solution only�

Fuse

To change the 5 Amp fuse:
1� Make sure the fan is off�
2� Remove the cap by turning it to the left to gain
access�
3� Replace with a type GMA 5A fast-acting fuse�
4� Replace the cap to secure the fuse in the holder�
2024 Classic