Kenwood TM-D700A Service Manual page 52

TM-D700A/E
ADJUSTMENT
Transmission section
Measurement Adjustment
Item Condition
Test-
oo .
Specifications/
. Unit | Terminal Unit Parts | Method
equipment remarks
TONE DEV 6) FREQ.:435,100MHz:E | Power meter] Rear
ANT
Check +0.2 ~ 0.7kHz
write or check TONE:88.5Hz Linear panel
Band B Transmission detector
[Narrow] Oscilloscope
(E type only)
DCS DEV For 1) and 4), Switch to | Power meter} Rear ANT Encoder | Write +0.8+0.15kHz
write or check | adjustment mode and
Linear —_ panel
[SET] key
Band A carry out the operations | detector
[Wide] for Item G. Oscilloscope
1) FREQ.:145.200MHz
Transmission
2) FREQ.:145.200MHz Check +0.5 ~ 1.3kHz
Transmission
[Narrow] 3) FREQ.:145.200MHz:E
Check +0.2 ~ 0.7KHz
(E type only) Transmission
Band B 4) FREQ.:445.200MHz:K
Encoder | Write
+0.8+0.15kHz
[Wide] FREQ.:435.200MHz: [SET] key
M4,E
Transmission
Check
+0.5 ~ 1.3kHz
5) FREQ.:445.200MHz:K
FREQ.:435.200MHz:
M4,E
Transmission
[Narrow] 6) FREQ.:435.200MHz:E
Check +0.2 ~ 0.7kKHz
{E type only) Transmission
Protection
1) Band A
Ammeter
Check 12.0A or less
check FREQ.:146.000MHz:K
FREQ.:144.975MHz:
M4,E
POWER:HI
ANT:short circuit and
open
2) Band B 12.0A or less
FREQ.:444.000MHz:K
FREQ.:435.000MHz:
M4,E
POWER:HI
ANT:short circuit and
open
Transmission
52
** At the end of adjustments, reconfirm "3. DEV".