Table of Contents
Advertisement
CX-W300
: ^ * A H T S . . 5 T
{R3HUT) a^OiTAOOJ
Playback
Head Azimuth Adjustment (Cassette 1)
(Figure 15)
1. Connect an
S S V M or oscilloscope to each of the headphones jack (dummy load 32 ohm) .
2. Playback an
8 kHz test
tape and turn the azimuth adjustment screw to obtain the maximum
output level of the left and
right
channels, in the forward and
reverse play modes.
3. When the output level of the left and
right
channels, and
forward and
reverse position differs,
zyxwvutsrqponmlk
1 . .
readjust to make the both channels, and
both directions at the same level.
!
4. After
adjustment, secure
the screw with lock paint or glue.
Record/Playback Head Azimuth Adjustment (Cassette 2)
(Figure 15)
1. Connect an
S S V M or oscilloscope to each of the headphone jack (dummy load 32 ohm) .
2. Playback an
8 kHz test
tape and turn the azimuth adjustment screw to obtain the maximum
output level of the left and
right
channels.
3. When the output level of the left and
right
channels differs,readjust to make the both channels
at the same level.
4. After
adjustment, secure
the screw with lock paint or glue.
or
- 9 -
Advertisement
Table of Contents
