Related Manuals for Genie Car2U
Summary of Contents for Genie Car2U
- Page 1 User Manual of Product 1: Genie ChainMax 1000 Garage Door Opener - Durable Chain Drive - Includes two 3-Button Pre-Programmed Remotes, Wall Console, Wireless Keypad, Safe-T-Beams - Model 3022-TKH, 140V DC Motor...
- Page 2 Press and hold buttons 1 and 3 for one second and release– all three LED’s will light solid RED. Press and hold the button (2 or 3) you want to change to Genie – the corresponding LED will flash. While continuing to hold the button you want to change, press and release button 1.
- Page 3 G3T (pictured right) one time. Both the long and round LEDs flash purple. Press the desired Car2U button for one second and release. Both the long and round LEDs go solid purple. Press the desired Car2U button (again) for one second and release. Both the long and round LEDs change from solid purple to solid blue and then go out.
- Page 4 Press the program button once - the long purple LED will begin flashing PRGM Press the desired Car2U button for one second and release. Press that same button again for one second and release. The long LED will flash blue and then turn off.
- Page 5 – PRGM release the button. The long LED will flash purple. Press the desired Car2U button for one second and release. Press that same button again for one second and release. The round LED and long LED will both turn blue and then turn off.
- Page 6 Press and release the learn code button - the red LED will begin to blink. Press the desired Car2U button one time. The red LED will stop blinking and stay Press the desired Car2U button one more time. The red LED will go out.
- Page 7 LED will begin to blink. CODE Press the desired Car2U button one time. The red LED will stop blinking and stay Press the desired Car2U button one more time. The red LED will go out. Pressing the Car2U button again will cause the garage door to move.
Need help?
Do you have a question about the Car2U and is the answer not in the manual?
Questions and answers
I have a 2019 Ford explorer how can i program to the Gennie opener
To program a Genie opener with the Car2U system in a 2019 Ford Explorer, follow these steps:
1. Enter Programming Mode:
- Press and hold the program button on the Genie opener until the round blue LED turns on, then release.
- The long LED will flash purple.
2. Program the Car2U Button:
- Press and release the desired Car2U button for one second.
- Press and release the same button again for one second.
- The round LED and long LED on the opener will turn blue and then turn off.
3. Test the Programming:
- Press the programmed Car2U button to check if the garage door moves.
If the opener has a red learn button instead:
1. Press and release the learn code button on the opener (the red LED will blink).
2. Press the desired Car2U button once. The red LED should stop blinking.
3. Test the button to confirm the door operates correctly.
For additional troubleshooting, refer to the user manual for your opener.
This answer is automatically generated