Table of Contents
Advertisement
USING THE POWER NUTRI CUP
IMPORTANT: Review all warnings on
pages 4–5 before proceeding.
NOTE: If the unit is plugged in, but the
jug or cup and blade assembly is not
properly installed, the timer will display
- -" and the motor will be disabled.
NOTE: Auto-iQ programs have pauses
and changes in speed throughout the
cycle.
NOTE: The Power Nutri Cup and Jug
share the Hybrid Edge Blade Assembly.
Unscrew from pre-assembled Jug.
WARNING:
Handle the Hybrid Edge
Blades Assembly with care, as the blades are
loose and sharp.
WARNING:
Remove utensils prior to
processing. Failure to remove may cause the
Power Nutri Cup to be damaged or to shatter,
which may cause personal injury.
WARNING:
Do not blend hot, effervescent,
or carbonated liquids. Doing so may cause
excessive pressure buildup, resulting in risk
of laceration and/or the user being burned.
WARNING:
Remove the Hybrid Edge
Blades Assembly from the Power Nutri Cup upon
completion of blending. Do not store ingredients
before or after blending them in the cup with the
blade assembly attached. Some foods may
contain active ingredients or release gases that
will expand if left in a sealed container, resulting
in excessive pressure buildup that can pose a risk
of injury.
10
AUS +61 2 8801 7666 | NZ +64 800 112 660
1 Plug in motor base and place on a clean,
dry, level surface such as a worktop or table.
2 Add ingredients to the Power Nutri Cup.
DO NOT add ingredients past the
MAX LIQUID line.
3 Place the Hybrid Edge Blades Assembly
on the top of the cup and turn clockwise
to seal.
4 Turn the cup upside down and install on
the motor base by aligning the tabs on
the cup with the slots on the base. Then,
rotate cup clockwise until it clicks. Once
locked in place, the available program
buttons will illuminate and the unit will
be ready for use.
5a If using an Auto-iQ program, select
the program that best suits your
desired output. The preset feature will
automatically stop at the end of the
program. To stop the unit at any time,
press the currently active program again.
5b If using START/STOP, once the
ingredients have reached your desired
consistency, press START/STOP again
and wait for the unit to come to a
complete stop.
6 Remove the cup from the motor base
by turning it anti-clockwise and then
lifting up.
7 Remove the blade assembly by twisting
anti-clockwise. DO NOT store blended
contents with the blade assembly
attached. Only use the Spout Lid to
cover. Exercise care when handling the
blade assembly, as the blades are sharp.
8 To enjoy on the go, place the Spout Lid
onto the cup and twist lid clockwise
until firmly sealed.
9 Unplug the unit when finished. Refer
to the Care & Maintenance section for
cleaning and storage instructions.
NOTE: If the motor base is difficult
to remove from the worktop or table,
slide it across the surface, then lift. It
shouldn't be forced as the suction cups
will grip more tightly to the surface.
ninjakitchen.com.au | ninjakitchen.co.nz
11
11
Advertisement
Table of Contents
