Kenwood VR-2090 Instruction Manual page 15

1D En/K)
t (RCA)
ofan AV
r
inputis
~
lin unit
~ G8)
elow.
can be
VR-2090/VR-2080/KAF-V888 1D/KRF-V777 1D (En/K)
Turning the power on for the first time
@ Check that all of the connections have been made properly.
© Plug the power cord into an AC wall outlet.
© Push the Power key on the front panel. (Except for U.S.A., U.S.
Military and Canada)
@ Press the ON/STANDBY key on the front panel.
Switching the display mode (DISPLAY MODE key)
Use the following procedure to switch the mode of the main unit display.
@ Press the DISPLAY MODE key.
Each press switches the mode as follows.
—> Connected component, analog/digital display Input and connected component name display-> Listen mode display>
(Example) (Example) ({Exampte})
DVD OGTL VIDEO3 : DVD DOLBY DIGITAL
{VIDEQO3 DGTL) (VIDEO3 : )
The display inside {_ } is shown when the connected component name is not assigned
Switching the IR RECEIVER mode (DISPLAY MODE key)
Use the following procedure to switch the IR remote contro! signal sensor (transmitter) in use between the transmitter on
the main unit and the IR RECEIVER.
@ Press and hold the DISPLAY MODE key for more than 2 seconds.
Each holding switches the mode as follows. (Possible with the VR-2090)
— IR RECEIVER OFF -+ IR RECEIVER B — IR RECEIVER A >
In case the multi-room function is not provided (i.e. except for the VR-2090)
-+ IR RECEIVER OFF — IR RECEIVER ON —
IR RECEIVER setting
The following table shows the IR RECEIVER setting and the status of associated functions.
. IR RECEIVER OFF JR RECEIVER B IR RECEIVER A IR RECEIVER ON
IR RECEIVER Setting (Common setting for all (Possible with (Possible with {Possible with other
models) the VR-2090} the VR-2090) models than VR-2090}
Purpose
Do not use
the IR RECEIVER.
Enables the "Room A"
and "Room B" setting.
Use the IR RECEIVER in
"Room A".
Use the IR RECEIVER.
Main Unit
sensor/ transmitter
Use the main unit
sensor/ transmitter
Use the main unit
sensor/ transmitter in
"Room A".
Disables the main unit
sensor/ transmitter.
Disables the main unit
sensor/ transmitter.
IR RECEIVER's
sensor (transmitter)
Disables the use.
Uses the IR RECEIVER's
sensor (transmitter) in
"Room B".
Uses the IR RECEIVER's
sensor (transmitter).
Uses the IR RECEIVER's
sensor (transmitter).