Kenwood VR-2090 Instruction Manual page 14

Multi-mode display
| Stereo indicator
TUNED indicator
KENWOOD
Y
(U.S.A., U.S. Military and Canada)
Press to switch power ON and OFF,
@ POWER key
(Except for U.S.A., U.S.Military and Canada)
(China : © POWER)
Press to switch the main power ON and OFF.
@ON/STANDBY key
{Except for U.S.A., U.S.Military and Canada)
Press to switch the power mode between
STANDBY and ON.
OSTANDBY indicator
Lights in STANDBY mode.
ORC sensor
Receives
signals transmitted
from the re-
mote control unit.
" @PHONES jack
Use for listening to audio through headphones.
@ SPEAKERS keys
Press each key to switch the SPEAKERS A or
SPEAKERS B ON and OFF.
CLIP INDICATOR :
Lights when the input is clipped during
analog to digital signal conversion.
-(22)
DOLBY DIGITAL :
Lights when Dolby Digital is activated.
DTS:
Lights when the DTS is activated.
[80]
O©MUTE key
Press to mute the audio temporarily.
~(45)
@RC transmitter
Sends signals to the remote control unit.
@ Indicator
Lights when signal is input frorn or output to
the remote control unit.
@ VOLUME control knob
Rotate to adjust the volume.
@®S VIDEO input jack
{Except for the VR-2080 or the KRF-V7771D
for the U.S. Military destination)
Connect the $ VIDEO output jack of an AV
component.
@ AUDIO {L, R) input jacks
Connect the audio output (RCA) jacks of an AV
component.
@CD2/TAPE2 MONITOR indicator
Lights when the CD2/Tape2 (Monitor) input is
used.
-Be
@DISPLAY MODE key
Press to switch the display on the main unit
~ Oi
@INPUT SELECTOR key
Press to switch the input as shown below.
TUNER
STANDBY indication
turned ON by remote control.