Table of Contents
Advertisement
100M ENTERTAINER STEREO MIXER
OWNER'S MANUAL
1. Send the signal to the MAIN outputs pan be
tween the speakers.
2. Send the signal into the monitors.
3. Equalize the signal with the tone controls.
4. Add reverb to the signal.
If the LINE/AUX inputs 9 and/or 10 are used, the fol¬
lowing can be done:
1. Send the signal to the MAIN outputs and pan it
between the speakers.
2. Send the signal to the monitors.
If the EFFECTS RETURN is used, the following can
be done:
1. Send the signal to the main outputs.
via a direct box or matching transformer (EV
#502CP).
Instruments having high output levels may be con¬
nected to inputs 9 or 10. If sound levels aren't high
enough, use inputs 1 through 8.
EXTERNAL EFFECTS
External effects are easily connected to the 100M. Be
sure to select the proper EFFECTS SEND jack for
your particular device.
Several points in the lOOM's mixer section may be
used for effects returns beside the EFFECTS
RETURN input. These are:
1. Line inputs 1 through 8
2. Line inputs 9 and 10
If the source is stereo, separate inputs must be used
(one panned left, the other right) to maintain stereo
separation. Otherwise, the sound is MONO!
Using either of these inputs allows the effects signal
into your monitors as well as the mains. Simply turn
up the monitor send control.
HOOKING UP INSTRUMENTS DIRECTLY
Instruments are best connected to the 100M through
one of the 8 High-Impedance/Line inputs or to one
of the Balanced Low-Impedance Microphone inputs
Be certain that the blend or mix control in the exter¬
nal effects device is set to the maximum or 100%
position. Failure to do this may result in overall
volume changes as the effect is brought in and out.
18
Advertisement
Table of Contents
