Table of Contents
Advertisement
100M ENTERTAINER STEREO MIXER
OWNER'S MANUAL
4
RIGHT/MAIN
SPEAKER FUSE
3 AMP 9LO-BLO
ON
ON
□□
PHANTOM
MAIN
POWER 44 V
POWER
1
.
1
CAUTION won
COMTTKJH)
ruplacc* *u* im rnmax oc
MoiKToiMUMrm
MMermccMMCMcxxiC
HA2AWD WFLACt wmiMME
TYW MI At »«CAnO.
100 120
u
CAUTION
DO MOT OPERATE
AMPLIFIER WTTM
LESS THAN 4-OHM
COMPLIED LOAD
IMPEDANCE.
CAUTION
THIS UNfT R EQUIPPED WITH A UN€ VOLTAGE
SWITCH. CONSULT MANUAL OP OUALnCO
SERVICE CENTER TOP PROPER SETTING M
YOUR AREA. IMPROPER SETTING WILL
RESULT IN DAMAGE TO UNIT.
LEFT/MONITOR
speaker fuse
3 AMP SIO-BLO
DO NOT OPERATE
AMPLIFIER WITH
LESS THAN 4-OHM
COMBINED LOAD
IMPEDANCE.
Pictorial 4 - Speaker Output Panel
the following combinations will work (examples refer
to ONE of the two amplifiers):
a. one 8-ohm speaker
b. one 4-ohm speaker
c. two 8-ohm speakers
d. two 4-ohm speakers (wired in series)
e. four 16-ohm speakers
f. any combination of speakers whose total im¬
pedance is 4 ohms or more
Operation of the internal amplifiers with loads below
the 4-ohm minimum (i.e. 2 ohms) may damage the
amplifiers. Such damage is not covered by the war¬
ranty.
Use high-quality cable and plugs (Switchcraft #280)
to connect your speakers to the 100M. For most pur¬
poses, 18-gauge "zip cord" is sufficient. For long runs
(more than 50 feet) heavier wire is recommended (16
or 14 gauge). For heavy-duty applications, consider
using type SVT or SJ portable cordage. It is much
better suited to putting up and tearing down than zip
cord. Shielded cable is neither necessary nor
desirable.
***CAUTION***
DO NOT USE COILED GUITAR CABLES FOR
SPEAKER CONNECTIONS. THEY ARE UNRELI¬
ABLE AND WILL WASTE AMPLIFIER POWER.
5. STEREO AND MONO MIXER OUTPUTS: The
STEREO and MONO outputs are the outputs of the
mixer section of the 100M. They may be used for tape
recording, external amplifiers, broadcast feeds, and
other external equipment.
Each of these jacks are line-level outputs. The signal
level is +4 dBu or 1.23 V rms when the fluorescent
bargraph display reads 0 VU. These outputs are not
affected by the graphic equalizers or the Mode
switch. The jacks may be used at any time without
interrupting the signal flow through the 100M. If plug¬
ging into one of these does interrupt the signal, the
cable is bad.
A. MIXER OUT, LEFT AND RIGHT: These are the
lOOM's stereo mixer outputs. Use them for simul¬
taneous recording or any of the other uses sug¬
gested above. If external power amplifiers are
connected here and recording is desired, use a Y
cord to connect them ail.
NOTE: Do not connect the outputs together with
a Y cord at any time.
10
Advertisement
Table of Contents
