Makita GRU06 Instruction Manual page 16

Correct combination of the cutting
tool and the guard
CAUTION:
Always use the correct combina-
tion of cutting tool and the guard. A wrong combi-
nation may not protect you from the cutting tool, flying
debris, and stones. It can also affect the balance of
the tool and result in an injury.
Cutting tool
Cutter blade
(2-tooth, 3-tooth, and 4-tooth
blades)
Nylon cutting head
Installing the guard
WARNING:
Never use the tool without the
guard or with the guard improperly installed.
Failure to do so can cause serious personal injury.
NOTE: The type of the guard supplied as the stan-
dard accessory varies depending on the countries.
For cutter blade
Attach the guard to the clamp using bolts.
2
Fig.17
► 1. Clamp 2. Guard
For nylon cutting head
the cutter for cutting the nylon cord.
Attach the guard to the clamp using bolts. After that,
install the guard extension. Insert the guard extension
to the guard and then snap the clips on. Make sure that
the tabs on the guard extension fit into the slots on the
guard.
Guard
Fig.18
► 1. Guard 2. Clip 3. Guard extension 4. Cutter 5. Slot
To remove the guard extension from the guard, unclasp
the clips by inserting the hex wrench as illustrated.
Fig.19
1
► 1. Hex wrench 2. Clip
Installing the cutting tool
to remove or to install the cutting tool.
inserted into the gear case after installing the
cutting tool.
NOTE: The type of the cutting tool(s) supplied as
the standard accessory varies depending on the
countries. The cutting tool is not included in some
countries.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
16 ENGLISH
CAUTION:
Take care not to injure yourself on
1
2
3
6. Tab
CAUTION:
Always use the supplied wrenches
CAUTION:
Be sure to remove the hex wrench
5
6
4
2
1