Removable Seat; Heated Seat (If Equipped); Towing - Yamaha SR1NLK Operator's Manual

Removable Seat

To remove the seat, remove the Torx-
head screw from the underside of the
seat; then lift on the back of the seat and
move it up and rearward to remove it.
CAUTION
Prior to removing the seat, lift the rear
of the seat and disconnect the seat
heater harness connector.
To install the seat, route the front tab on
the seat through the seat-base hold-down
bracket; then install the seat and secure
using the Torx-head screw.

NOTE: Prior to lowering and secur-
ing the seat, connect the seat heater
harness connector.
Heated Seat
Some models are equipped with a heated
seat. Models with this option can be
adjusted with a HIGH and LOW switch
which will be located near the gas tank cap.
12
0747-739
SNO-273
(if equipped)
! WARNING
People who are unable to feel pain to
the skin because of advanced age,
chronic illness, diabetes, spinal cord
injury, medication,
exhaustion, or other physical condi-
tions, must exercise care when using
the seat heater. The seat heater may
cause burns even at low temperatures,
especially if used for long periods of
time. Do not place anything on the seat
that insulates against heat, such as a
blanket or cushion, because this may
cause the seat heater to overheat. Do
not puncture the seat with pins, nee-
dles, or other pointed objects because
this may damage the heating element
which may cause the seat heater to
overheat. An overheated seat may
cause serious personal injury.

Towing

If the snowmobile is to be towed by
another snowmobile, do not tow using
the loops in the skis. The tow rope should
be attached to the lower A-arms.
SNO-766
alcohol use,