Table of Contents
Advertisement
2.
Dispose of the dust inside the dust case and
remove any dust and powder adhered to the surface of
the mesh filter.
3.
Insert the dust case all the way until the two but-
tons lock with a click.
2
Fig.42
► 1 . Dust case 2. Button (two locations)
NOTE: Check that the cyclone attachment, cleaner,
and straight pipe are locked properly before restarting
operation.
NOTE: If the suction force does not recover even
after disposing of the dust and cleaning the mesh
filter, check whether dust has accumulated in the dust
bag of the cleaner or clogging has occurred.
Cleaning
When the dust case becomes dirty or the mesh filter is
clogged, remove and wash them with water. (Refer to
"Disposing of dust" for the removal procedure.)
Dry the parts thoroughly before reinstallation and use.
1
Fig.43
► 1 . Dust case 2. Mesh filter
When the mesh filter gets dirty badly, clean it in the
following procedures.
1.
it while the hooks are unlocked.
1
Fig.44
► 1 . Mesh filter 2. Hook
2.
it with water. After that, dry it thoroughly.
3.
are aligned with the port. Turn the mesh filter clockwise
until the hooks are locked with a click. Make sure that
the mesh filter is installed securely.
2
Fig.45
► 1 . Mesh filter 2. Hook 3. Port
19
ENGLISH
Turn the mesh filter counterclockwise and remove
Remove the dust on the mesh filter and then wash
Insert the mesh filter into the base while the hooks
1
1
2
2
3
Advertisement
Table of Contents
