Makita GA044G Instruction Manual page 13

2. While pushing the lock lever toward A, hold down
the portions B of the wheel guard as shown in the
figure.
B
Fig.7
► 1. Wheel guard 2. Hole
NOTE: Push down the wheel guard straight.
Otherwise, you cannot secure the wheel guard.
B
A
1
2
3. While pushing the lock lever toward A, rotate the
wheel guard toward C, and then, change the angle of
the wheel guard according to the work so that the oper-
ator can be protected. Align the lock lever with one of
the holes in the wheel guard, and then release the lock
lever to lock the wheel guard.
C
Fig.8
► 1. Wheel guard 2. Hole
To remove wheel guard, follow the installation proce-
dure in reverse.
Installing depressed center wheel or
flap disc
Optional accessory
WARNING:
wheel or a flap disc, the wheel guard must be
fitted on the tool so that the closed side of the
guard always points toward the operator.
Fig.9
► 1. Depressed center wheel 2. Wheel guard
13 ENGLISH
A
C
1
2
When using a depressed center
1
2