Lincoln Electric SPEEDTEC 200C BR Operator's Manual page 8

Controls and Operational Features
Figure 1
1. EURO Socket: For connecting a welding gun (for
GMAW / FCAW-SS process).
2. Positive Output Socket for the Welding
Circuit: For connecting an electrode
holder with lead / work lead.
3. Negative Output Socket for the Welding
Circuit: For connecting an electrode
holder with lead / work lead.
4. Left Knob: The value of parameter in the upper left
side of display [7] is adjusted.
5. Right Knob: The value of parameter in the upper right
side of display [7] is adjusted.
6. Set Knob: Type of welding procedure and welding
settings is changed by this knob.
7. Display: Parameters of welding process are shown.
8. User Button (left): Button function could be set:

Advanced menu:

Recalls advanced menu (default)

Recalls user memory.

Inductance.

Run-in WFS.

Burnback.

Basic menu – changes basic menu for advanced
menu.
9. Escape Button (right):

Cancels an action / exit menu.

Locks and unlocks knobs and buttons on the panel
(press and hold button for 4 seconds).
English
10. Power Switch ON/OFF (I/O): Controls the input power
to the machine. Be sure the power source is
connected to the mains supply before turning power
on ("I"). After input power is connected and the power
switch is turned on, the indicator will light up to
indicate the machine is ready to weld.
11. Gas Connector: Connection for gas line.
12. Power lead: Connect the supply plug to the existing
input cable that is rated for the machine as indicated in
this manual, and conforms to all applicable standards.
This connection shall be performed by a qualified
person only.
13. Wire Drive (for GMAW, FCAW-SS process): 2-Roll
wire drive.
14. Welding Wire (for GMAW / FCAW-SS).
15. Spooled Wire (for GMAW / FCAW-SS): The machine
does not include a spooled wire.
6
Figure 2
Figure 3
English