Table of Contents
Advertisement
FIRMWARE UPDATE -1
How to Check Versions of Main, DSP(1st to 3rd), HDMI and Video FW
1. Press and hold down [DISPLAY] button, then press [STANDBY/ON] button when the unit is powered on.
The main microprocessor version will be displayed on Front Display for about 3 seconds.
<e.g.>
M a in :
8 7 1 .0 3 /0 7 9 0 3 A
2. Press [Tone +] button while the version is displayed. Then, "DSP 1st SR8051/07601A" will be displayed.
Press [Tone +] button again while "DSPS8051:07601A" is displayed. Then, "DSP 2nd: SR8052/07518A" will be
displayed. In this way, as [Tone +] button is pressed while a version is displayed, the next information will be displayed.
If [Tone -] button is pressed, the order will be reversed.
[Tone -]
Note: These versions are the latest as of October 1, 2007.
M a in :
8 7 1 .0 3 /0 7 9 0 3 A
DS P 1 s t:
SR 8 0 5 1 :07 6 0 1 A
DS P 2 n d :
SR 8 0 5 2 :07 5 1 8 A
DS P 3 r d :
SR 8 0 5 3 :07 8 2 0 B
HDMI:
1 .0 1 /0 7 7 06 A
Vid e o :
0 7 6 0 6 E O0 9 2 4
Ne t:
1 .0 0 /0 7 6 0 2 A
[Tone +]
Attetion:
Video FW cannot be reloaded.
Board replacement is necessary for newer version.
(Network Installed Model only)
TX-SR875
Advertisement
Table of Contents
