Table of Contents
Advertisement
en Childproof lock
9.4 Setting the end time
You can delay the time at which cooking is due to fin-
ish by up to 23 hours and 59 minutes.
Notes
¡ The end time cannot be set for types of heating with
grill function.
¡ In order to achieve a good cooking result, do not
delay the end time once the appliance is already in
operation.
¡ Food will spoil if you leave it in the cooking com-
partment too long.
Requirements
¡ The type of heating and temperature or setting are
set.
¡ A cooking time is set.
Press the
button repeatedly until
1.
lighted in the display.
Press the or
button.
2.
a The display shows the calculated end time.
Use the
or
button to delay the end time.
3.
a After a few seconds, the appliance applies the set-
ting and the display shows the set end time.
a Once the calculated start time has been reached,
the appliance starts heating up and the cooking
time starts counting down.
a Once the time has elapsed, an audible signal
sounds and the display shows the cooking time as
zero.
When the cooking time has elapsed:
4.
Press any button to end the signal prematurely.
‒
To set another cooking time, press the
‒
When your food is ready, switch off the appli-
‒
ance.
10 Childproof lock
You can secure your appliance to prevent children
from accidentally switching it on or changing the set-
tings.
Note: After a power cut, the childproof lock is deactiv-
ated.
12
Changing the end time
In order to achieve a good cooking result, you can only
change the set end time before operation starts and
the cooking time starts counting down.
Requirement:
Use the
▶
a The appliance applies the change after a few
seconds.
Cancelling the end time
You can delete the set end at any time.
Requirement:
Reset the end time to the current time plus the set
▶
cooking time using the
a After a few seconds, the appliance applies the
change and starts heating up. The cooking time
is high-
counts down.
9.5 Setting the time on the clock
Once the appliance has been connected to the mains
or following a power failure, the time flashes on the dis-
play. The time starts at "12:00". Set the current time.
Requirement: The function selector must be set to the
"Off" position .
Use the
1.
Press the
2.
a The time that is set appears on the display.
Changing the time on the clock
You can change the time on the clock at any time.
button.
Requirement: The function selector must be set to the
"Off" position .
Press and hold the
1.
flashes on the display.
Use the
2.
a The appliance applies the change after a few
seconds.
10.1 Activating and deactivating the
childproof lock
Requirement: The function selector must be set to the
"Off" position .
To activate the childproof lock, press and hold the
▶
‒
is highlighted on the display.
or
button to delay the end time.
is highlighted on the display.
button.
or
button to set the time.
button.
button until the clock
or
button to change the time.
button until appears in the display.
To deactivate the childproof lock, press and hold
the
button until goes out in the display.
Advertisement
Table of Contents
