Table of Contents
Advertisement
C ONT RO L PANEL AN D OPER ATION
When your fridge is first connected to the DC power
input the appliance will automatically switch on
and the LCD control panel will display the current
cabinet temperature and cooling speed setting as
well as the current input voltage.
TEMP. DISPLAY
POWER ON/OFF BUTTON
POWER
1. Press
button to turn fridge ON.
2. Press
button again to turn
fridge OFF.
TEMPERATURE SETTING
1. Press
to set temperature. Wait for 3
sec for display to stop flashing, then setting
will be saved and display will change to actual
temperature reading
BATTERY PROTECTION
1 Press & hold
button for 3 seconds to enter
battery protection setting mode
2 Press the
button again to cycle between the
3 protection levels - H1 (Hi) -> L3 (Low) ->
N2 (Med)
3 Wait for 3 seconds for the display to stop
flashing, then the setting will be saved and the
display will show the actual temperature reading
+ The Temperature Controller provides the ability
to set the desired temperature level and display
the current cabinet temperature. The electronic
controller has been programmed to maintain an
average of the set temperature.
+ The compressor will start up when the internal
cabinet temperature increases 0.5 to 1.5 degrees
above the set temperature and will run until the
temperature is 0.5 to 1.5 degrees below the set
temperature.
TEMPERATURE SCALE
1. Press & Hold
and
switch between Celcius (°C) or Fahrenheit (°F)
MAX/ECO MODE
1. Press
button to switch between MAX mode or
ECO mode
MAX - Indicator will show green light
ECO - Indicator will show white light
POWER OFF MEMORY
If power is cut to the fridge, the ON/OFF status,
mode and temperature settings will resume to the
previous settings as soon as the power is restored.
8
UP AND DOWN BUTTONS
SET BUTTON
buttons for 3 sec to
Advertisement
Table of Contents
