Osd Description And Functions - VocoPro ENTERTAINER Owner's Manual

OSD Descriptions and Functions
Preset Menu
The PRESET menu allows you to select and setup your TV for broadcast channels, select an
antenna type, delete channel(s) from roster and perform a channel auto-search.
To enter the PRESET menu, hit the MENU button the Remote Control three times or press the
MENU button on the front panel three times. Use the NAVIGATION buttons to maneuver through
and execute from the possible settings.
Channel
The CHANNEL line is used to change the channel while the PRESET window is still superimposed
on the screen for adjustments.
Delete
The DELETE line is used to delete a channel from the channel roster. Use the CHANNEL line
(above) to find the channel you want to delete, then go to the DELETE line and press the RIGHT
arrow to delete it. To add a channel back to the channel roster, repeat the steps to delete channel.
Note: Even though a channel is deleted, you can still access it by manually entering the channel
with the NUMBER PAD.
Antenna
When setting up your antenna it is recomended to first set the Antenna Selector. (see pg 12).
The antenna line is used to select the antenna you are using to for broadcast reception. You can
choose from AIR or CABLE:
• AIR - Built in Antenna, external antenna lead-ins connected to 75-ohm jack.
• CABLE - For a cable-in lead from cable provider to 75-ohm jack only.
Auto Search
The Auto Search feature scans all channels available and determines whether or not the
frequency/channel is "active" and added to the channel roster. If available, the channel is
programmed and then selectable via the channel controls. If not deemed active, the channel will not
appear in the channel roster. You can still direct input the channel via the remote control, however
reception will not be satisfactory. It would then be recommended to reconfigure your antenna setup,
and repeat the channel search. Be sure to auto-search after an antenna configuration.
Note: Preset menu is only available when TV Function is selected on the Input Selector.
17