Table of Contents
Advertisement
Fault
"E:30 / -80"
"E:36 / -25 / -26"
"H:32"
"E:30 / -10" and/or
"E:35 / -10"
Cause and troubleshooting
Install the water outlet hose at a maximum height of
▶
1 metre.
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose.
→ "Connecting the appliance", Page 14
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 37.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 43.
▶
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
Clean the water inflow filter.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
There is water in the base trough.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 60
The appliance is leaking.
Troubleshooting en
47
Advertisement
Table of Contents
