Table of Contents
Advertisement
AD INSTRUMENTS
Troubleshooting
This chapter lists the commonly encountered failures of AD8660and their
solutions. When you encounter these problems, please solve them following the
corresponding steps below. If the problem remains still, please contact
INSTRUMENTS
and provide the device information (Press SYS to get it).
Failure Phenomena
The screen of the generator
is still dark (no display) after
switch on.
CH2 is locked.
Set correctly,
but no waveform output
40
1) Check whether the power is correctly connected.
2) Check whether the power switch has been pulled
in place.
3) Restart the instrument after finishing the above
inspections.
4) If it still does not work correctly, please contact
INSTRUMENTS.
1) Check that the signal generator is operating in
synchronous state. Press the SYNC button to enter
the synchronization settings interface to cancel all
synchronization parameters.
2) If the problem is still, please restart the generator.
1) Check whether the BNC cable is connected tightly
with CH1 or CH2 connector.
2) Check whether the BNC cable has internal
damage.
3) Check whether the BNC cable is connected tightly
with the test instrument.
4) Check whether the indicators of CH1 or CH2 is
turned on. If not press corresponding button to turn
it on.
5) If the problem is still, please contact
INSTRUMENTS.
Solutions
AD8660 Series User's Manual
AD
AD
AD
Advertisement
Table of Contents
