Table of Contents
Advertisement
4
Arrows
5
ADJ Knob
Power
6
Button
CH1 channel
7
output
connector
Output
8
Channels
CH2 channel
9
output
connector
AC coupling
10
measuring
terminal
AD8660 Series User's Manual
— VCO function can be set
— Frequency, Amplitude, Bias and Duty of
VCO Voltage Control Signal Generator
— Output function of various parameters such as VCO.
Press Arrow buttons to select figure which you want to
edit when setting values of each parameter.
Press the knob as confirmation (OK button).
— Rotate the ADJ Knob to increase or reduce the current value
indicated by the cursor.
—
Frequency unit can be changed by Press ADJ Knob under
Frequency value setting status.
— Press ADJ Knob to Start/Stop sweep under Sweep interface.
The power indicator keeps illuminating when power on.
Press the power button and the indicator change to notify light status
and the signal output terminates.
CH1 connector, output impedance is 50Ω.
When CH1 channel activates (indicator illuminates), CH1 outputs
signal with parameters set.
Control CH1 output. Press it to switch to CH1 parameter
setting interface.
—
Press it to turn on CH1 output with current
configuration. The indicator will illuminate.
—
Press it again to turn off CH1 output and the indicator
will extinguish.
Control CH2 output. Press it to switch to CH2 parameter
setting interface.
—
Press it to turn on CH2 output with current
configuration. The indicator will illuminate.
— Press it again to turn off CH2 output and the indicator
will extinguish.
—Confirm key
—When editing the frequency parameters, the unit of
frequency can be changed by pressing the knob down.
—When scanning the interface, press down the knob to
start/stop the scanning state.
CH2 connector, output impedance is 50Ω.
When CH2 channel activates (indicator illuminates), CH2 outputs
signal with parameters set.
BNC connector, input impedance 100Ω. For inputting signal of meter or
counter.
AD INSTRUMENTS
9
Advertisement
Table of Contents
