Westinghouse iGen4000c User Manual page 18

Digital inverter generator
Hide thumbs Also See for iGen4000c:
Table of Contents

Advertisement

Available languages

Available languages

OPERATION
l Turn the generator battery switch to the ON position. The
power indicator light will illuminate.
l Push and hold the electric start switch on the control
panel for 10 seconds. The button illuminates and starts
flashing.
l Push and hold the ON button on the key fob. It should
automatically pair with the generator and the electric start
switch will stop flashing.
l Turn the generator battery switch to the OFF position.
The remote is now paired.
Remote replacement batteries: (2) CR2016
STARTING THE GENERATOR
See Figures 13 - 14.
l Place the generator in a safe, appropriate location.
l Unplug all loads.
l Ensure the ECO mode switch is in the OFF position.
l Check oil and fuel levels. If needed, add fuel or oil as
described earlier.
l Place the engine/fuel control switch in the on ( I )position.
FIG. 13
C
A - Engine/fuel control switch
B - Run
C - OFF
D - Pull recoil handle
18 | English
To start the generator using the recoil handle:
l Firmly grasp and slowly pull the recoil handle until you feel
To start the generator using the engine control
switch:
l Place the battery switch in the on ( I )position.
l Choose the starting method:
 •  R emoteStart: Push and hold the START button on the
 •  P ush-ButtonStart:Push and hold the engine START/
 •  R ecoilStart: Manually close the choke if the engine is
FIG. 14
D
K
A
A - 120 Volt AC 20 amp receptacles
B - 120 Volt AC 30 amp receptacle
B
C - Parallel operation outlets
D - ECO mode switch
E - Reset button
F - 20 amp circuit breaker
G - USB ports
H - Overload LED
I - 30 amp circuit breaker
J - Output ready LED
K - Battery switch
L - Electric start switch
increased resistance. At this point, rapidly pull the recoil
handle away from the generator until the engine starts.
NOTE: Gently return the recoil handle into place after
starting the unit. Do not let it snap back against the unit.
During initial starting, additional pulls may be required to
prime the fuel pump.
remote start key fob for one second.
STOP button for two seconds.
cold. Firmly grasp and pull the recoil handle slowly until
you feel increased resistance, then pull rapidly.
NOTE: If the battery switch and start button does not start
the generator, the generator's battery may need to charge.
G
E
D
J
I
F
H
B
C
H
J
L
A

Advertisement

Table of Contents
loading

Table of Contents