Parameters - Roland DDR-30 Owner's Manual

c. Parameters
VOICE GROUP
The parameters in this group can change
the volume and the sensitivity of dynamics.
Source number
-а
i
ELE
ПЕН НИТ hl.
НГЕ Е мл
This is the parameter that selects one of
the four digital drum sounds (Sources)
provided for each drum voice. The sound
selected here can be edited by changing
the values of the following parameters.
Level
This adjusts the volume of the sound. The
volume of each drum sound in a Drum
Set combination needs adjsuting to even
the volume difference. At value of 0, there
is no sound produced, and towards 99,
the higher sound is produced.
Envelope Decay
This sets the time required for the sound
note to fade out (= decay time).
PITCH GROUP
The parameters in this group decide the
pitch, the sensitivity of the pitch bend
effect.
Pitch
OTT E:
r LL.
4
This sets the pitch for each drum sound.
Variable from —24 to +24 within two
octaves.
Bend Depth
Ти
L
1 Т1 11 IET La
ч i кз Ed
This sets the sensitivity of the pitch bend
effect. At "0", there is no pitch bend effect
obtained, and towards "99", effect
becomes deeper. When the Pitch value is
"—24", however, there is no pitch bend
effect regardless of the value of the bend
depth.
Bend Decay
|
THT NET ЛГ Rv а. С]
ПЕНИ } 99
This adjusts the time needed for the pitch
to come down to the set depth of the
bend depth {= pitch bend speed). At
"1" the speed is fastest and towards
"99", slower pitch bend effect is obtain-
Attack Level ed
ГЭЛ ТЕНТ be Pi onm
FL OILS ыд
Dynamics Sensitivity
This sets the highest level to which a note
Tht MOE
| ЖТ ЕЗЕТ
can reach. In other words, weaker or Е CUED ew L- 883
stronger attack can be selected. When the
pads are played gently, there is no attack
obtained whatever value is set here.
Attack Decay
а CIC
1-99
This sets the decay time of the attack
sound.
|
This sets the sensitivity of the pitch bend
effect. As the value is increased, the sen-
sitivity is emphasized, that is, deeper pitch
bend is obtained by harder hit on the pads.