Daikin MTKM50UV16V Operation Manual page 28

1) Strip wire ands (15mm).
2) Match wire colours with terminal numbers on indoor and outdoor
unit's terminal blocks and firmly scrow wiros to tho corrosponding
terminals with the screw.
3) Connoct tho Harth wirns to the corresponding terminals.
Attach tho oarth wire so that it is not connoctod to tho fan motor eonnoctoL
4) Pull wires to make sure that they are securely latched up, then retain wires
with wire retainer.
5) Shape the wires so that the service lid fits securely, tt1en close service lid.
Firmly fix the wiree with
the terminal eorews
Indoor
unit
Lt.
WAR N I N G - ----------- ----------- ------------ -ll-b l ,_N_• _ ·
• Use a stabiliser if required by the voltage supply co11d1t1011.
• Do not use tapped wires, extension cords, or starburst connections, as they may cau•e overheating, electrical shock, or fire.
, llo not use locally purchased electrical parts inside the product. (llo not branch the power for the drain pump, etc., from the
tnrminal block.) Doing so may causo oloctric shock or firo.
Piping
1) Connect the drain hose, as described right.
2) Remove the air filters and pour some water into the drain pan to check the water
flows smoothly.
3) When drain hose requires extension, obt11111 an extension hose commarc,ally available.
Be sure to thermally insulate the indoor section of the extension hose.
4) When connecting a rigid polyvinyl chloride pipe (nominal diameter
13mm) directly to the drain t1ose attad1ed to the indoor unit as with
embedded piping work, use any commercially available drain
socket (nominal diameter 13mm) as a joint.
7
Indoor Unit
1