Table of Contents
Advertisement
1. PLACEMENT
OF THE MOUNTING
PLATE
A=
REMOVING
THE
MICROWAVE
OVEN FROM
THE CARTON/REMOVING
THE MOUNTING
PLATE
1.
Remove the installation
instructions,
Exhaust
adaptor,
filters, glass tray, and the small
hardware
bag. Do not remove the Styrofoam
protecting
the front of the oven.
2.
Fold back all 4 carton
flaps fully against
carton
sides. Then carefully roll the oven and carton
over onto the top side. The oven should
be
resting in the Styrofoam.
Styrofoam
3.
Pull the carton
up and off the oven.
4.
Remove and properly
discard
plastic bags.
Screws
Screws
Mo°°,,°0P,o,e
5.
Remove the 2 screws from the mounting
plate.
This plate will be used as the rear wall template
and for mounting.
NOTE: You will have to reuse two screws
in original
Ioction of outcase
after removing
mounting
plate.
B.
FINDING
THE WALL
STUDS
1,
Find the studs using one of the following
methods:
A. Stud finder-a
magnetic
device which locates
nails.
OR
B. Use a hammer to tap lightly across the
mounting
surface to find a solid sound. This
will indicate
a stud location.
2.
After locating
the stud(s), find the stud's center
by probing the wall with a small nail to find the
edges of the stud. Then, place a mark halfway
between
the edges. The center of any adjacent
studs should
be 16" or 24" from this mark.
3.
Draw a line down the center of the studs.
THE MICROWAVE
MUST
BE CONNECTED
TO
AT LEAST
ONE WALL
STUD.
SM H 1816_XAA-DE68-03943A-02-EN_120725.indd
8
2012-07-25
7:49:14
Advertisement
Table of Contents
