Table of Contents
Advertisement
Quick Links
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
BIG ASS FANS VESPER® ELECTRIC HEATER
MODELS
BAFDS15120B
BAFDS32080B
BAFDS32240B
During operation, always ensure combustible materials are kept at a safe distance from the heater
body and from the emitted radiant energy. This heater is not intended for use in hazardous areas where
flammable vapours, gases, liquids or other combustibles are present. Failure to do so can result in
personal injury/or property damage.
FOR OUTDOOR COVERED OR INDOOR USE, IN BOTH COMMERCIAL AND RESIDENTIAL
BIG ASS FANS dba DELTA T LLC
RADIANT INFRARED ELECTRIC HEATER
VOLTAGE (V)
120
208/240
208/240
FIRE/EXPLOSION HAZARD WARNING
NOT FOR USE IN HAZARDOUS OR EXPLOSIVE ATMOSPHERES
LOCATIONS IN MODERATE CLIMATES
2348 INNOVATION DR. LEXINGTON KY 40511
TOTAL POWER (W)
1500
1800/2400
2400/3200
CURRENT(AMPS)
12.5
8.7/10
11.5/13.3
PHONE: 877.BIG.FANS
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BIG ASS FANS BAFDS15120B
Summary of Contents for BIG ASS FANS BAFDS15120B
- Page 1 Failure to do so can result in personal injury/or property damage. FOR OUTDOOR COVERED OR INDOOR USE, IN BOTH COMMERCIAL AND RESIDENTIAL LOCATIONS IN MODERATE CLIMATES BIG ASS FANS dba DELTA T LLC 2348 INNOVATION DR. LEXINGTON KY 40511 PHONE: 877.BIG.FANS...
-
Page 2: Table Of Contents
TABLE OF CONTENTS SAFETY ................................3 INSTALLATION INSTRUCTIONS ........................5 INSTALLATION CLEARANCES – WALL MOUNT .................... 5 INSTALLATION CLEARANCES – CEILING MOUNT ..................6 INSTALLATION ON HIGH CEILINGS ......................7 ELECTRICAL INSTALLATION ......................... 8 WALL-MOUNTED INSTALLATION ........................ 8 CEILING MOUNTED INSTALLATION ......................9 ADJUSTING DIRECTIONAL POSITIONING ....................10 MAINTENANCE .............................11 CLEANING ..............................11... -
Page 3: Safety
IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following outlined in section 1 – SAFETY. Read all instructions before installing or using this heater. 1 - SAFETY WARNINGS WARNING: FIRE OR EXPLOSION HAZARD... - Page 4 WARNING: PERSONAL INJURY HAZARD - CLEANING AND MAINTENANCE ● To avoid property damage, personal injury or death ● Before cleaning the unit or replacing the emitter, due to electrical shock DO NOT service the unit turn off the main power. Make sure the heater without turning the unit OFF and disconnecting the and/or the emitter is cool before handling.
-
Page 5: Installation Instructions
2 - INSTALLATION INSTRUCTIONS Heater installation must be carried out by qualified personnel in compliance with local National Codes (NEC) as well as any other applicable standards. Failure to comply with applicable requirements could result in personal injury and/or property damage. Wiring procedures and connections shall be made in accordance with national and local electrical codes having jurisdiction. -
Page 6: Installation Clearances - Ceiling Mount
INSTALLATION CLEARANCES – CEILING MOUNT This heater works best when installed 8’ in Canada, and 7’ in USA when measured to the bottom of the heater. The minimum mounting height in Canada is 8’, and 6’7” in USA measured to the bottom of the heater. In outdoor environments it is not recommended to mount the bottom of the heater above 8’. -
Page 7: Installation On High Ceilings
INSTALLATION ON HIGH CEILINGS When installing the heater on high ceilings, it is highly recommended to suspend the heater to ensure optimal heating performance. In outdoor environments it is not recommended to mount the bottom of the heater above 8’ in CANADA and 7’ in USA. This section will help the installer select an optimal extension bracket to ensure the heater is installed at the optimal height. -
Page 8: Electrical Installation
ELECTRICAL INSTALLATION Safety Precautions 1. Each power supply circuit must be properly grounded. 2. Use a certified ground fault protection device for wet environment installations. 3. Use a proper electrical connection box. 4. Supply voltage and frequency must correspond to the electrical rating indicated on unit’s information plate. -
Page 9: Ceiling Mounted Installation
CEILING MOUNTED INSTALLATION Heater should be hung using rigid mounting brackets, the unit must not be able to swing in any direction under applied load from wind or WARNING persons. The unit must be installed using the supplied brackets or Aura Shadow extension brackets. -
Page 10: Adjusting Directional Positioning
ADJUSTING DIRECTIONAL POSITIONING Never attempt to move or adjust the heater angle while it is running. Personal WARNING injury could result. 1. Turn off the heaters electrical supply line from the main power supply. 2. Allow the heater to cool before adjusting the angle. 3. -
Page 11: Maintenance
3 - MAINTENANCE WARNINGS 1. Allow the heater and the emitter to cool down before handling. Installation and maintenance must be performed by a qualified technician. Turn off the power before beginning maintenance. Do not attempt to service or repair the unit while it is running. 5. - Page 12 BIGASSFANS.COM/PRODUCT-WARRANTIES...
Need help?
Do you have a question about the BAFDS15120B and is the answer not in the manual?
Questions and answers