Table of Contents
Advertisement
4.5.2.
ARGON GAS OR ARGON MIXTURES. Cylinders containing Argon gas and Argon mixtures have a female thread and will require the use
of a Bull Nose Adaptor to attach the regulator to the cylinder as indicated in fig.4. Ensure that the threads on the gas bottle are undamaged
and free of oil and grease before attaching the regulator. (Oil or grease in the presence of high pressure gases is explosive).Fit the
Bull Nose Adaptor to the cylinder first and tighten with a spanner. Ensure that the regulator has an undamaged gasket before fitting
onto the Bull Nose Adaptor. Tighten with a spanner.
4.5.3.
Slide a clip over each end of the gas hose supplied. Push one end of the hose onto the regulator outlet and the other end over the gas
inlet spigot on the back of the welder. See fig.2G. Tighten the clips to ensure a good seal.
4.5.4.
Close the regulator valve by turning it anti-clockwise before opening the cylinder valve. Stand to one side when opening the cylinder valve.
4.5.5.
Set the regulator flow rate to 5-8 litres/min depending on the material to be welded, and whether there are draughts which are strong
enough to disturb the gas flow.
4.6.
CONNECT THE TORCH CABLE TO THE WELDER. Align the pins on the Euro connector with the socket on the welder front panel
as shown in fig.5. Push the connector into the socket and rotate the locking ring (A) clockwise so that it draws the plug into the
socket as shown in fig.6.
NOTE: damage to torches and cables is not covered by warranty.
4.7.
FITTING A 15KG REEL OF WIRE. Ensure that the wire diameter used, is matched by the correct groove size in the drive wheel and
the correct tip size on the torch as well as the correct torch liner. Failure to do this could cause the wire to slip and/or bind.
4.7.1.
Unscrew the locking knob from the end of the spool holder (see fig.7C) and remove the spacer (fig.7B). The spacer is not required for
15kg reels of wire. Slide the reel of wire onto the spool holder and ensure that the clutch pin at the back of the spool holder (fig.7E)
engages into the guide hole in the wire reel moulding. This will prevent the wire reel from freewheeling on the spool holder. Ensure
that the wire is coming off the bottom of the reel in the direction of the wire drive unit as shown in fig.8.
4.8.
FITTING A 5KG REEL OF WIRE. Ensure that the wire diameter used, is matched by the correct groove size in the drive wheel and
the correct tip size on the torch as well as the correct torch liner. Failure to do this could cause the wire to slip and/or bind.
4.8.1.
Unscrew the locking knob from the end of the spool holder (see fig.7C) and remove the spacer. Slide the reel of wire onto the spool
holder and ensure that the clutch pin at the back of the spool holder (fig.7E) engages into the guide hole in the wire reel moulding. This
will prevent the wire reel from freewheeling on the spool holder.
4.8.2.
Slide the spacer onto the spool holder and retain it by screwing the knob into place as shown above in fig.9. Ensure that the wire is
coming off the bottom of the reel in the direction of the wire drive unit as shown in fig.10.
© Jack Sealey Limited
fig.5
fig.7
fig.9
fig.10
Original Language Version
fig.8
SUPERMIG200.V2 Issue 1 11/07/22
fig.6
Advertisement
Table of Contents
