Power Cord Caution - Pioneer VSX-425 Operating Instructions Manual

REAR PANEL FACILITIES
i2 CENTER SPEAKER terminals
Connect the center speaker to these terminals.
NOTE:
Do not allow any of the cord's conductors to protrude from the
terminals or touch any other conductors. Malfunctioning or
breakdowns may occur when conductors come into contact
with each other. Use center speakers with impedance of 8&2 to
7682.
1f REAR SPEAKERS terminalis
Connect the rear speakers to these terminals.
NOTE:
e Do not allow.any of the cord's conductors to protrude from
the terminals or touch any other conductors. Malfunctioning
or breakdowns may occur when conductors come into con-
tact with each other. Use rear speakers with impedance of
SQ to 76a.
e Be sure to connect two speakers {L, R). There will be no sound
if only one speaker is connected.
'4 Power cord
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power cord
when your hands are wet.as this could cause a short
circuit or electric shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the cord.
Never make a knot in the cord or tie it with other cords.
The power cords should be routed such that they are not
likely to be stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the power
cord once in a while. When you find it damaged, ask your
nearest PIONEER authorized service center or your deal-
er for a replacement,
<ARB7066>