Table of Contents
Advertisement
rae
-=T 957 yoy
[ Setting Up the AM Antenna
® insert the claw on the bottom of the antenna into the groove
in the Jeg.
@ Place the antenna on a level surface and rotate it te locate the
orientation that yields the best reception.
@ Use the attachment hole in the leg to screw to a wall or other
location, then insert the claw on the bottom of the antenna
into the groove in the leg (fixing the antenna in the direction
that gives the best reception.)
Lead wire
Lead wire
@ The rear panel vents are designed to disperse heat from the
unit, Be careful that curtains or other items do not block the
vents.
® To improve heat dispersion, set the unit so that it is at least 20
em (8 inches) away from the wall,
At least 20 cm (8 inches)
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by
tugging the cord and never touch the power cord when your
hands are wet as this could cause a short circuit of electric shock,
Do not place the unit, a piece of furniture, etc., on the power
cord, or pinch the cord. Never make a knot in the cord or tie it
with other cords. The power cords should be routed such that
they are not likely to be stepped on. A damaged power cord can
cause fire or give you an electrical shock. Check the power cord
once in a while. When you find it damaged, ask your nearest
PIONEER
authorized
service
center
os your
dealer
for a
replacement.
Precaution regarding installation position
of cassette deck
Hf the cassette deck is installed in the @ positions shown in the
drawing below, it may be adversely affected during playback, lf
possible, it's better to install it in the © position.
7
<ARB7083>
Advertisement
Table of Contents
