Power Cord Caution; Cleaning The Unit - Pioneer XRB3059-A Operating Instructions Manual

Additional information
Miscellaneous
Power requirements:
. . . . . . . . . . . . . . . . . .AC 110 V/AC 120 V to 127 V/
AC 220 V/AC 240 V, 50 Hz/60 Hz
Power consumption . . . . . . . . . . . . . . . . . . 360 W
In standby. . . . . . . . . . . .0.5 W(AC 220 V/50 Hz)
Dimensions
. . . . . . 420 (W) mm x 158 (H) mm x 352.5 (D) mm
Weight (without package). . . . . . . . . . . . . . .9.0 kg
Furnished Parts
Microphone (for Auto MCACC setup) . . . . . . . . .1
Dry cell batteries (AA size IEC R6)
Remote control . . . . . . . . . . . . . . . . . . . . . . . . . . .1
AM loop antenna . . . . . . . . . . . . . . . . . . . . . . . . . .1
FM wire antenna . . . . . . . . . . . . . . . . . . . . . . . . . .1
Power cords:
VSX-816-K (black model). . . . . . . . . . . . . . . . . .2
(Round 2-pin type and Australian type)
VSX-816-S (silver model) . . . . . . . . . . . . . . . . . .4
(Round 2-pin type, flat blade 2-pin type,
UK 3-pin type and Australian type)
Power plug adaptor (VSX-816-K only) . . . . . . . . . .1
J-shaped plug. . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
These operating instructions
Note
• Specifications and the design are subject
to possible modifications without notice,
due to improvements.

Power cord caution

Handle the power cord by the plug. Do not pull
out the plug by tugging the cord and never
touch the power cord when your hands are wet
as this could cause a short circuit or an electric
shock. Do not place the unit, a piece of
furniture, etc., on the power cord, or pinch the
cord. Never make a knot in the cord or tie it
with other cords. The power cords should be
routed such that they are not likely to be
stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the
power cord once in a while. When you find it
damaged, ask your nearest Pioneer authorized
service center or your dealer for a replacement.

Cleaning the unit

• Use a polishing cloth or dry cloth to wipe
off dust and dirt.
• When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser
diluted five or six times with water, and
wrung out well, and then wipe again with a
dry cloth. Do not use furniture wax or
cleansers.
• Never use thinners, benzine, insecticide
. . . . . . . . . .2
sprays or other chemicals on or near this
unit, since these will corrode the surface.
14
65
En