Controlling The Tv Or The Av Receiver With The Supplied Remote - Sony DVP-S300 Operating Instructions Manual

To change the password *
1 In Step 5, select "CHANGE PASSWORD" using _ / _,, then
press ,,_ or ENTER.
The display for changing the password appears.
2 Follow Steps 4 and 5 to enter a new password.
"(_° If you have forgot your password
Enter six digits number "199703" in Step 4 to clear the
current password. To enter a new .password, follow the
procedure from Step 4 again.
Notes
• When you play DVDs which do not have the Parental
Control function, playback cannot be limited on this player.
• When you do not set a password, you cannot change the
settings for playback limitation.
• Depending on the DVD, you may be asked to change the
parental control level while playing the disc. In this case,
enter the password, then change the level.
When you stop playing the DVD, the level returns to the
original level.
Standard Code number
Austria 2046
Belgium 2057
Canada 2079
China 2092
Denmark 2115
Finland 2165
France 2174
Germany 2109
Hong Kong 2219
Indonesia 2238
Italy 2254
Japan 2276
Malaysia 2363
Netherlands 2376
Norway 2379
Philippines 2424
Singapore 2501
Spain 2149
Sweden 2499
Switzerland 2086
Taiwan 2,543
Thailand 2528
United Kingdom 2184
Controlling the TV or the AV
receiver with the Supplied
Remote
If you adjust the remote signal., you can control your
TVs with the stupplied remote. Default setting is to
control Sony TVs with the [] mark.
When you connect the player to a Sony AV receiver,
you can also set the input of the receiver to this player
with the supplied remote.
TV/DVD --
switch
Number --
buttons
--L. ) -
®®®1 o
CS) CD CD CS)
CD CD CS) CD CD
-- POWER
Controlling TVs with the remote
1
Slide TV/DVD switch to TV.
2 Hold down POWER, and enter your TV's
manufacturer's code in the table below using the
number buttons. Then release POWER.
Code numbers of controllable TVs
If more than one code number is listed, try entering
them one at a time until you find the one that works
with your TV.
Notes
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote commander,
the code number automatically resets to 01 (Sony). Reset the
appropriate code number.
30 EN