Table of Contents
Advertisement
¡The water hardness level is 0 -
6 °dH. You can do without special
salt.
press.
1.
To open the basic settings,
2.
press.
aThe display shows H:xx. a
The display shows .
or press repeatedly until the
3.
display shows H00.
To save the settings,
4.
Press for 3 seconds.
aThe softening system is equipped
switches on and the salt refill
indicator is deactivated.
10.5 Regenerate the softening
system
In order to maintain the trouble-free
function of the softening system, the
device regenerates the softening
system at regular intervals.
The softening system is regenerated
in all programs before the end of the
main rinse cycle. The running time and
consumption values increase, e.g. B.
Water and electricity.
Overview of the consumption values
when regenerating the
Softening system
Here you will find an overview of the
maximum additional running time and
consumption values when regenerating
the softening system.
Regenerating the softening
system after x rinsing
corridors
Additional term i
ten
Additional consumption of
in liters
3 seconds
6
6
n minute
Water 5
Additional consumption of electricity
in kWh
The stated consumption values are
laboratory measurements according
to the currently valid standard and
determined using the Eco 50°
program and the factory-set water
hardness value of 13 - 16 °dH.
11 Rinse aid system
11.1 Rinse aid
For optimal drying results, use rinse
aid.
Only use rinse aid designed for
household dishwashers.
Fill in rinse aid
If the rinse aid refill indicator lights
up, add rinse aid. Only use rinse aid
designed for household
dishwashers.
The tab on the lid of the rinse aid
1.
reservoir
press and lift.
Rinse aid systemde
0.05
2
1
29
Advertisement
Table of Contents
