Hitachi RC-AGU1EA0G Manual page 17

My Mode(Programming)
Programming of My Mode
If operation of remote controller will not be done for 10 seconds during My Mode programming, remote controller
will come out from My Mode programming without registering of My Mode Programming.
without registering of My Mode Programming, My Mode selection will remain with all previously selections and
previous values.
If My Mode button is kept pressing for 5 seconds during My Mode Programming, remote controller will come
out from My Mode programming.
without registering of My Mode Programming, My Mode selection will remain with all previously selections and
previous values.
If battery is replaced or
reset to default settings.
if new settings are required, do My Mode Programming again.
When Operation Mode Lock is set, selectable mode during My Mode will be limited.
On Timer Setting Selection
Press (On Timer) button in order to select On Timer setting during
" " blinks.
6
" " blinks on the LCD.
Setting time will change according to the below sequence when you press
the button.
Set Temp. -0.5Hr. -1.0Hr. -2.0Hr-3.0Hr.......... -10.0Hr. -11.0Hr -12.0Hr.
Off Timer Setting Selection
Press (Off Timer) button in order to select Off Timer setting during
" " blinks.
7
" " blinks on the LCD.
Setting time will change according to the below sequence when you press
the button.
Set Temp. -0.5Hr. -1.0Hr. -2.0Hr-3.0Hr.......... -10.0Hr. -11.0Hr -12.0Hr.
Register of My Mode Programming
Once all desire setting completed , press
8
" " blinks.
All selection will be saved to remote controller and room air conditioner.
(Reset) button is pressed, My Mode Programming on remote controller will be
- 17 -
Cancel ON Timer
Cancel OFF Timer
(On/Off) button during