ICP EDM Series Installation Instructions Manual

These instructions must be read and understood completely before attempting installation.
It is important that the Blower and Duct System be properly sized to allow the system to operate at full capacity. Poorly
designed systems will not give satisfactory cooling or economy. They may even shorten the service life of the
compressor in the outdoor unit.
Safety Labeling and Signal Words
DANGER, WARNING, CAUTION, and
NOTE Signal Words in Manuals
The signal words DANGER, WARNING, CAU- The signal word WARNING is used throughout this
TION, and NOTE are used to identify levels of haz- manual in the following manner:
ard seriousness. The signal word DANGER is only
used on product labels to signify an immediate haz- 7IN WARN i NG
ard. The signal words WARNING, CAUTION, and
NOTE will be used on product labels and through- The signal word CAUTION is used throughout this
out this manual and other manuals that may apply manual in the following manner:
to the product.
DANGER - Immediate hazards which will result in yi CAUTION
severe personal injury or death.
WARNING - Hazards or unsafe practices which Signal Words on Product Labeling
could result in severe personal injury or death. Signal words are used in combination with colors
CAUTION - Hazards or unsafe practices which and/or pictures on product labels.
may result in minor personal injury or product or
property damage.
NOTE - Used to highlight suggestions which will
result in enhanced installation, reliability, or opera-
tion.
TABLE OF CONTENTS
Installation... eee eee 2-4
Condensate Drain
4-5 7 IN
WARN
i NG
Waste Line Connection ........ 0... cece eee ees 5 ELECTRICAL SHOCK HAZARD
Refrigerant Line Connections ................0 00s 6 Failure to turn off electric power could result in
Refrigerant Metering Device ......... 0.2.00 eee 7 personal injury or death.
Check and Adjust Airflow ............. 0000s 7-8 Before installing or servicing system, turn off
Start-Up Procedure ...... 00... cece eee e eens g | main power to the system. There may be more than
R-410A Quick Reference Guide...............0.. 9 ee switch, including accessory heat-
484 01 3001 03 Nov 2007