Attaching The Feet; Operation - Supra QUICKMIX 2 Instruction Manual

With optional remote control
With adaptable ON/OFF control
With time-limit operation
With black light sensor
Contact details:
INSTALLATION:
• Itis imperative to respect the «Safety Instructions»
• Attach the 2 feet and tighten the screws provided.
• Unwind the power cable fully.
• Connect to a 230V ~ 50Hz power socket, protected with a 16A fuse.
• To avoid any danger caused by the thermal cut-out being accidentally reset, this appliance
must not be powered via an external switch, such as a timer, or be connected to a circuit that
is regularly switched on and off by the electricity supplier.
• Stand the appliance on a level floor (never on a thick carpet).

ATTACHING THE FEET

• Place the unit in a horizontal position.
• Place one bracket in front of the holes and insert it into the tabs.
• Secure the foot using the 2 screws provided.
• Repeat the procedure with the other foot.

OPERATION

ON/OFF Portable installation:
• Use your foot to operate the ON/OFF switch (Fig. 7).
THERMOSTAT
• Select the power level by turning the power knob A1 or A2 (Fig. 9 and 10). See power table
• Select the desired temperature using the thermostat control B.
• (Fig. 11)
• After reaching the desired temperature, slowly turn the thermostat control anticlockwise until
you hear a "click". ". The desired temperature is now set.
• FROST PROTECTION
• Connect the heater by setting button A1 or A2 to I or II and set the thermostat button B to
frost protection (Fig. 11), when the room temperature drops to about 5°C, the appliance
starts heating. This keeps the temperature somewhere above 5°C and stops the room from
freezing.
«TURBO» FAN
• The Quickmix 2-2000 convection heater is equipped with a fan to accelerate hot air
circulation throughout the room.
No
No
No
No
SUPRA FRANCE
BP 22 – 67216
OBERNAI Cedex
FRANCE